Parts Included:
1
- Assembled Back
1
- Assembled Seat
1
- Set of Arms
1
- Assembled Base
1
- Backboard
2 - Arm Supports (left & right)
ASSEMBLY INSTRUCTIONS
Swivel Rocking Dining Chair
Tools Not Included but Required:
7/
1
6" wrench, socket & ratchet and a power drill
Tools Included:
#2 Square Drive Bit, 4mm Allen Wrench
Stainless Steel Hardware
Included:
Assembled Back
8 - 3-
1
/2" Bolts
4 - 3" Bolts
2 - 2-
1
/2" Bolts
4 -
1
-5/8" Deck Screws
14
- Nuts
14
- Flat Washers
14
- Lock Washers
4 - Lock Nuts
2 - Rectangular
2 Holed Washers
Assembled Seat
Hardware
Arm Supports
Arms
Assembled Base
1
. Place the assembled base onto a flat surface. Then place the seat onto
2. Determine your left and right assembled arm supports. The screws
holding the assembled arm supports together should face in towards
each other. Place a 3-
1
/2" bolt through all 8 holes of the assembled arm
supports and into the seat. Place a flat washer, lock washer and nut
onto each bolt and hand tighten only.
Step
1
Backboard
the base lining up the bolts coming out of the horizontal seat support with the
holes in the fiberglass springs. Make sure the seat is facing the correct direction.
Step
2
The horizontal seat support should almost entirely be resting on the fiberglass springs. Then, one
bolt at a time, line up the 2 holed washer with those same bolts and place a lock nut onto each
bolt. Place all 4 nuts onto all 4 bolts first and then tighten.
