ASSEMBLY INSTRUCTIONS
Single Glider
Tools Not Included but Required: 7/16" wrench, either a power tool, hand driver, or ratchet wrench
that will accept a ¼" hex drive bit
Tools Included: # 2 square driver bit, 4 mm allen wrench
Materials Included:
1) Assembled Seat
2) Assembled Back
3) Assembled Arms
4) Assembled Leg Sets
5) Leg Supports
6) Bag of Hardware
Step 1
Begin by unfolding the two assembled legs
sets as shown. You can determine your left and
right side by looking at the four legs that need to be
unfolded. The front legs are the one’s with no angle
to them. The back legs will have an angle cut on
the top because it needs to sit on an angle. The
two leg sets need to face each other with the
notch’s facing inward.
Step 2
There are three leg supports for this chair.
Two of them are the same length and size. There
will be one made out of a two by four and two
made out of smaller stock lumber. You will need to
begin with the two that are the same size.
Stainless Steel Hardware Included:
2 - 2" stainless steel screws
8 - 3" lag screws
8 - 3 1/2" bolts
4 - 3" bolts
2 - 2 1/2" bolts
14 - flat washers, lock washers, & nuts
Step 1a
Start the assembly by plac-
ing the two leg supports in
the notch’s on one of the
leg sets. Then take a three
inch lag screw and screw it
through the leg set and
into the leg support until
tight, using the 4 mm allen
wrench provided. Repeat
this step for the other side.
Step 1b
Step 2a
Step 2a
closer
