PERCo Turnichetul TB 1, Assembly & Operation Manual

Page: 27 / 37

Assembly and Operation Manual
11.
26
TRANSPORTATION AND STORAGE
11.1 The turnstile in the original package should be transported in closed freight
containers or other closed type cargo transport units.
11.2 During storage and transportation the boxes with the turnstiles can be
stacked maximum 2 layers high.
11.3 Storage of the turnstile is allowed in dry indoor facilities at an ambient air
temperature from -40° С to + 45° С at relative air humidity 80% at 15° С .
11.4 After transportation or storage at temperatures below zero or at high air
humidity, prior to installation the turnstile must be kept in the original
package for no less than 24 hours indoors under conditions corresponding
to operation conditions (Ref. Section 2).
12. MAINTENANCE
The turnstile maintenance is required once a year and in case of any technical fail-
ures the turnstile must be serviced immediately after repair works. The maintenance
should be carried out by qualified mechanic only after careful study of this Manual.
12.1 To do maintenance proceed as follows:

Disconnect the turnstile power supply from the AC mains;

Remove the turnstile top cover (3) from the turnstile housing as described in
Section 6;

Lay the cover on a flat steady surface;

Inspect the resetting mechanism (a pusher, springs and a roller), optic sensors
and a damper (Ref. Fig. 10);

Remove dust from a rotation sensor disc, located in the spacing of the rotation
optic sensors, with alcohol-gasoline blend applied with a cloth. Avoid ingress of
dust into the operational spacing of the optic sensors;

Lubricate with machine oil:
– four bushes of the resetting mechanism (two – on the rotation axis of
the pusher, two – on the fastening axis of the springs as well as holes
in the fastening parts of the springs); 2-3 drops of oil in each lubrication
point (lubrication points are marked in Figure 10). Avoid ingress of
lubricant on the rotation sensor disc and the roller surfaces.
– lock cylinders of the mechanical release lock (7) and top cover lock (4)
from a side of the keyhole (4);

Check reliability of the cable connections to the CLB connector blocks and if
necessary tighten the cable fixing screws;

Check reliability of the barrier arm (5) fastening, to do so:

unscrew the cover (6) screw М 4 х 25 with a screw driver and take off
the cover (6);

tighten the М 8 х 30 bolts of the barrier arms with the S13 socket wrench
if necessary;

put the cover into its operating position and fix it with the screw.

Check reliability of the turnstile housing fastening to the floor and if necessary,
tighten the anchor bolts with S17 socket wrench.