ST-02 Speed gate and STD-02 Double-sided section
21
The speed gate in the standard delivery set is packed in shipping boxes that protect it from being
damaged during transportation and storage. Parts and fasteners of each section are supplied in
two boxes, fastened together. The total number of boxes (assemblies) depends on the ordered
delivery set.
Overall dimensions of transportation boxes (length × width × height)
:
ST-02.600:
box No.1, box No.3 ....................................................................................... 205×45×121
cm
box No.2, box No.4 ......................................................................................... 131×45×27 cm
STD-02.600:
box No.1 ....................................................................................................... 205×45×121 cm
box No.2 ......................................................................................................... 131×45×27 cm
ST-02.900:
box No.1, box No.3 ....................................................................................... 205×60×121 cm
box No.2, box No.4 ......................................................................................... 131×60×27 cm
STD-02.900, STD-02.600/900:
box No.1 ....................................................................................................... 205×60×121 cm
box No.2 ......................................................................................................... 131×60×27 cm
Weight (gross) of transportation boxes
:
ST-02.600:
box No.1, box No.3 .................................................................................... max. 255
kg each
box No.2, box No.4 ...................................................................................... max. 55 kg each
STD-02.600:
box No.1 ............................................................................................................. max. 268 kg
box No.2 ............................................................................................................... max. 58 kg
ST-02.900:
box No.1, box No.3 .................................................................................... max. 265 kg each
box No.2, box No.4 ....................................................................................... max.65 kg each
STD-02.900, STD-02.600/900:
box No.1 .............................................................................................................. max. 280 kg
box No.2 ................................................................................................................ max.68 kg
7 SAFETY REQUIREMENTS
7.1 Installation safety requirements
Installation of the speed gate should be carried out by persons who have fully studied this manual
and briefed the safety instruction, in compliance with the General rules of electrical and installation
works.
Attention!
•
All installation work is carried out only when all power sources, both main and
backup (emergency) are switched off!
•
Use only properly functioning tools during the mounting procedures.
•
The speed gate sections are heavy and require at least 4 people to unpacking and
moving procedures. Installation of glass top covers and sliding panels, replacement of
the filling glasses should be carried out by at least two persons.
•
The use of protective gloves is mandatory! Parts of the housing are made of stainless
steel and may have sharp edges.
•
Be especially careful and accurate when installing the speed gate sections and prevent
them from falling over when they are not fixed yet.
•
Be careful, do not to insert your fingers into the technological slots and holes of
the housing in order to avoid injuries, use a special tool instead!
•
Make sure that installation and all connections are correct before you turn the speed
gate on for the first time.
Installation of power supplies should be carried out in accordance with the safety precautions given
in their service documentation.
