FP-01C
Front panel for ST-01 Speed gate
3
4 PRODUCT DESCRIPTION
4.1
Main features
•
In the front panel of the card capture reader there is a container with a lock for card collection.
•
Card reader (to be purchased separately) can be built in the panel, it should be installed inside
at the upper part of the card capture reader panel using the double-sided tape. In this case the
identifier is read from the proximity card that is inserted in the slot of the card capture reader.
•
The slot for card withdrawal has a built-in LED backlight.
•
The slot for card withdrawal has a form that allows the card capture reader to withdraw cards
with the standard clips for badges.
•
The slot for card acceptance is equipped with a protective shutter, preventing the ingress of
foreign objects into the container as well as cards that are not subject for withdrawal.
•
The card capture reader features optical sensors allowing to correctly record the fact of capture
of proximity cards, as well as the filling of the container of the card capture reader.
•
The card capture reader is supplied with the safe voltage
– no more than 28 V.
•
The card capture reader has low power consumption
– no more than 56 W.
4.2 Card capture reader mechanism control
Card capture reader mechanism operation algorithm:
1. In a standby mode of proximity card presentation, the card capture reader slot is always backlit by
the built-in LED indicator. Built-in speed gate reader reads the proximity card identifier and sends
the signal to the ACS external controller for analyzing.
2. If the presented proximity card belongs to an employee and
shouldn’t be withdrawn, in this case
the ACS-controller allows the passage through the turnstile in the specified direction (sends the
signal to the turnstile control mechanism). The shutter which blocks the access to the card
capture container remains closed preventing the accidental card withdrawal. The card slot
backlight remains constant.
3.
If the presented card is a temporary visitor’s card and should be withdrawn, then the ACS-
controller sends the signal to the card capture reader control board input "Capture card"
(INPUT
XT1,
see Fig. 2). The card slot backlight will switch to the flashing mode of 2 times per
second indicating that the card should be withdrawn.
4. If after receiving the signal the optical sensor in the card capture reader detects presence of a
card in the slot, then the solenoid opens the shutter that blocks access inside the card reader
and the card falls into the container
– thus the withdrawal procedure is finished. If the optical
sensor doesn't detect the presence of a card in the slot, then the card slot remains blocked.
5. The second optical sensor registers the fact of withdrawal when you drop the card into the
container. In this case, the "Card captured"
control signal is sent from the output of the control
board of the card capture reader to the ACS-controller and serves as a confirmation of the
withdrawal of the card and activates the passage permission. Upon receiving the signal, the
ACS-controller permits the passage in a specified direction and deactivates the "Capture card"
signal from the input of the control board of the card capture reader.
6. The third optical sensor monitors overfill of the container with cards. When a container is
overfilled, the card capture reader sends the "Alarm" signal to the ACS-controller (
XT2
Alarm
output, Fig. 2); 2 seconds on / 2 seconds off indication warns the operator that it is necessary to
empty container from cards. The card capture reader operation will be blocked after it receives
another 9 cards if the container is not emptied. Unblocking of the card capture reader and
deactivation of the "Alarm" signal will occur automatically when the container is emptied from
cards (see Sect. 4.3). Also, the "Alarm" signal is sent to the ACS-controller in case the card
capture reader is broken.
Note:
Blocking temporary card withdrawal does not impact the card capture reader functioning on
employees
’ permanent cards and visitors’ cards which should not be withdrawn.
Summary of Contents for FP-01C
Page 21: ......
