User Manual
40
3.2 Change of controller network setting
The controller has the following configurations by default (they are specified in the certificate of the
device and on the labels on the controller):
•
MAC-address
00-25-0B-xx-xx-xx
, where
xx
– is a number from
00
to
FE
;
•
IP-address
10.x.x.x
, where
x
– is a number from 0 to 254;
•
Subnet mask
255.0.0.0
.
To change network settings of the controller:
1. Click consistently
Settings
Network
in the Web-interface menu. The page with working
area will be opened:
2. In the
IP-address
,
Mask
,
Gateway
input fields
set
the new values of controller network
settings.
3. Click the
Save
button. New network settings will be saved in the controller.
3.3 Change of server settings
In order to change the server settings, proceed as follows:
1. Click
Settings
Server
in the Web-interface menu. The page with working area will be
opened:
2. In the opened window make the necessary changes for the parameters:
•
Server address
parameter sets the server address.
•
Encryption
parameter sets the encryption method:
No
or
SSL
.
3. Click the
Save
button. New network settings will be saved in the controller.
3.4 Setting of the controller access password
By default, access password of the controller is not specified. To change or set the new password:
1. Click
Settings
Password
in the Web-interface menu. The page with working area will be
opened:
2. In the
New password
field enter the new password of the controller, in the
Confirm
password:
field enter the password again to confirm the correct input.
3. Click the
Save
button. The new password will be saved in the controller.
3.5 Reading format of the card
identifiers
Attention!
•
Change of this parameter, after the access cards having already been registered, results
in the passage on these cards being denied.
