User Manual
38
1. WEB-INTERFACE OPPORTUNITIES
Using Web-interface without installation of additional software allows performing following steps for
the controller and connected devices:
•
Change network settings, access password and time of built-in clocks of the controller.
•
Configure settings of operating device, readers and other equipment of the controller.
•
Set ACM for operation devices.
•
Record the access card numbers in the controller memory, assign them the rights for arming or
disarming.
•
Monitor event log of the controller and save them as a file.
•
Control the status of the controller and connected devices, monitor the event log.
•
Troubleshoot the controller, format the memory and update the embedded software.
Attention!
It is possible only with the Web-interface:
•
Select controller configuration template.
•
Add and delete optional readers in configuration.
2. CONNECTION TO WEB-INTERFACE OF THE CONTROLLER
Connection between the controller and the computer is performed via
Ethernet
interface (IEEE
802.3). Make sure that the computer and the controller are on the same subnet
Ethernet
. It may
become necessary to change network settings of the computer, browser settings and to check
operation of the network. IP-address of the controller is specified in the certificate and the controller
board.
To connect the controller to Web-interface:
1. Open Web-browser (e.g.
Internet Explorer
).
Attention!
Web-interface was tested with the Web-browsers:
Microsoft IE
version 10 or higher,
Chrome
version 32 or higher,
Mozilla Firefox
version 32 or higher,
Opera
version 30 or
higher,
Microsoft Edge
and for
MacOS
Apple Safari 9
or higher. If other browsers and
outdated versions are used, malfunctions of the Web-interface can appear.
2. Enter IP-address of the controller in the address bar and press the
Enter
button on the
keyboard. If necessary, enter the access password to the controller. By default, there is no
password.
3. After that the main Web-page of the controller interface will be opened. Version, configuration,
network settings of the controller and embedded software version will be displayed on the
main page. At each opening of the page, current controller data will be displayed. The page
looks as follows:
