Barcode Scanner VB14A
INSTALLATION
Subject to reasonable modifications due to technical advances.
Copyright Fuchs, Printed in Germany
Fuchs Group • Tel.: Germany (06 21) 7 76-0 • USA (330) 4 25 35 55 • Singapore 7 79 90 91 • Internet http://www.pepperl-fuchs.com
Da
te of
issue
12/
2
005
27
6.5
Typical Layouts
The following typical layouts refer to system hardware configurations. Dotted lines in
the figures refer to optional hardware configurations within the particular layout.
These layouts also require the correct setup of the software configuration parameters.
Complete software configuration procedures can be found in the
Guide To Rapid
Configuration
in the VisoSetup Help On Line.
6.5.1
Point-to-Point
In this layout the data is transmitted to the Host on the main serial interface. Host
Mode programming can be accomplished either through the main interface or the
Auxiliary interface.
In Local Echo communication mode, data is transmitted on the RS232 auxiliary
interface independently from the main interface selection.
When On-Line Operating mode is used, the scanner is activated by an External
Trigger (photoelectric sensor) when the object enters its reading zone.
Figure 6.21
Point to Point layout
1
2
3
VB14A
1 Main serial interface
2 Auxiliary serial interface (Local Echo)
3 External Trigger (for On-Line mode)
Host
Terminal
VB14A