Pepperl+Fuchs ODT-MAC400 Series, Manual, Page: 20 / 64

21
6677
201
2-
05
20
ODT-MAC400-* / ODT-MAC401-* / ODT-MAC403-*
Operation
7.1.1 Settings Tab
The Settings tab enables you to configure various parameters and send
commands to the sensor. In the left display area, you can navigate to the other
tabs Communication , Gallery and Language .
In the center of the screen, the following functions are available in different fields:
Sensor parameters
Settings Explanation
Flash duration This parameter is used to set the duration of the flash at
intervals of 10
µ
s.
Gain This parameter is used to set the electronic brightness gain. A
high value electronically increases the brightness of the
captured image and can improve the readability of the code
considerably in the event of poor ambient conditions.
Parameter set Load from Flash: Use this button to load parameter settings
from the internal memory (Flash EEPROM).
Save to Flash: Use this button to save your current parameter
settings in the internal memory (Flash EEPROM).
Command Send individual commands to the sensor.
Reset counter The trigger counter value can be reset to 0 here.