ODT-MAC400-* / ODT-MAC401-* / ODT-MAC403-*
Installation
21
6677
201
2-
05
13
ODT-MAC403-*
Figure 5.3
Dimensions of the
angle
housing
5.3
Connecting the device
Connecting the power supply
To connect a power supply to the device, proceed as follows.
1. Plug the 15-pin Sub-D socket into the connector provided for this purpose on
the back of the housing.
2. Screw in the two mounting screws as far as possible.
This ensures that the cable cannot be inadvertently pulled out.
3. Next connect the power supply to the appropriate pins on the Sub-D socket.
The power supply has now been connected.
To connect the power supply to the device quicker, the pre-configured connection
cable can also be used. Information can be found in the Accessories section.
Reading distance
11
60
60
65
M5
20
6
11
Code
52.7
20 ±0.1
54.5
Note!
Connection to ground
When installing the device, ensure that it is has a ground connection.
Note!
Record the network configuration
The device communicates with the connected machine control system using the
TCP/IP protocol. To ensure communication works correctly, you must note down
all the changes you make to the network configuration.