Pentek 52791, Getting Started Manual

Page: 9 / 14

Model 52791 Getting Started Guide Page 9
Rev. 1.0
FPGA Configurations
Following are the Xilinx Virtex − 7 FPGA options for the Model 71791 XMC module:
 Option 073 is a Xilinx XC7VX330T − 2 FPGA

Option 076 is a Xilinx XC7VX690T − 2 FPGA
Model 71791 is shipped with a default FPGA configuration on FLASH memory. Model
71791 loads the FPGA configuration from FLASH memory at power − up. Up to four
FPGA configurations can be stored in FLASH, identified as Version 0, Version 1, Ver −
sion 2, and Version 3. The default FPGA configuration is located in the Version 0 space.
The other three positions are empty.
The 71791 is shipped with the FPGA configuration SW (
SW1-2
) set to ON, which sets
the board’s maximum speed to Gen 3 x8. However, the Model 5201 carrier limits the
number of lanes to x4. For more information, refer to Section 2.4 in the Model 52791
Installation Manual .
Documentation Required for Installation
• Pentek Model 52791 Installation Manual (800.52791): Provides installation
instructions for the Model 52791.
•
Pentek Model 71791 Operating Manual
(800.71791): Describes the operation and
programming of the Model 71791 XMC module (which is part of the Model 52791).
• Installation and Getting Started Guide for the Pentek ReadyFlow software for the
workstation platform you’re using (Windows or Linux)
•
GateFlow User Manual