Pentax K 100D Super, Operating Manual

Page: 139 / 220

137
5
F
uncti
on Re
ferenc
e
Metering is weighted at the center of the
screen. Use this metering when you want
to compensate the exposure by
experience, instead of leaving it to the
camera. The illustration shows that
sensitivity increases as the pattern height
increases (center). This mode does not
automatically compensate for backlit scenes.
With spot metering, brightness is
measured only within a limited area at the
center of the screen as shown in the
illustration. You can use this in
combination with the AE lock (p.148)
when the subject is extremely small and
proper exposure is difficult to obtain.
Using the Center-Weighted Metering
Using the Spot Metering
Linking AF Point and AE During Multi-Segmented
Metering
In [Link AF Point and AE] (p.106) of the [
A
Custom Setting] menu,
you can link the exposure and AF point in the focusing area during
multi-segment metering. The default setting is [Off].
1
Off Exposure is set separately from AF point.
2
On Exposure is set in accordance with AF point.
Setting the Meter Operating Time
Sets the exposure metering time in [Meter Operating Time] in the
[
A
Custom Setting] menu (p.106). The default setting is [10 sec].
1
10 sec Sets exposure metering timer to 10 seconds.
2
3 sec Sets exposure metering timer to 3 seconds.
3
30 sec Sets exposure metering timer to 30 seconds.