212
5
App
e
nd
ix
Raise the mirror up and open the shutter to clean with a blower. Please
contact PENTAX service center for professional cleaning because the
CCD is a precision part. Cleaning services involve a fee.
You can use the Imagesensor Cleaning Kit O-ICK1 (optional) when
cleaning the CCD.
1
Turn the camera off and remove the lens.
2
Turn the camera on.
3
Select [Sensor Cleaning] in the [
R
Set-up] menu.
4
Press the four-way controller (
5
).
The Sensor Cleaning screen appears.
Removing Dust with a Blower
• Do not use a spray type blower.
• Do not clean the CCD when the exposure mode is set to
p
(Bulb) mode.
• Always cap the lens mount area to prevent dirt and dust from accumulating
on the CCD when no lens is on the camera.
• When the battery level is low, [Not enough battery remaining to clean sensor]
is displayed on the LCD monitor.
• If you are not using the AC adapter D-AC50, please use batteries with ample
capacity remaining. A warning beep will sound if the battery capacity
becomes low during cleaning. Please stop cleaning immediately.
• Do not put the tip of the blower inside the lens mount area. If the power is
turned off, this could cause damage to the shutter, CCD sensor or the mirror.
• It is recommended to use the AC adapter D-AC50 (optional) when cleaning
the CCD.
• The self-timer lamp blinks and [Cln] appears on the LCD panel while cleaning
the CCD.
• This camera features a CCD shifting shake reduction system, and it may
generate some operating noise while cleaning the CCD. It is not a
malfunction.
