172
4
Func
tion
Refere
nce
Using the Built-in Flash
You can change the flash output in a range of –2.0 to +1.0. The Flash
Compensation values are as follows for 1/2 EV and 1/3 EV.
* Set interval of steps in [EV Steps] in the [
A
Custom Setting] menu. (p.162)
Turn the rear e-dial to set [Flash Mode] in the Fn menu (
Compensating Flash Output
Step interval
Flash Compensation
1/2 EV
–2.0, –1.5, –1.0, –0.5, 0.0, +0.5, +1.0
1/3 EV
–2.0, –1.7, –1.3, –1.0, –0.7, –0.3, 0.0, +0.3, +0.7, +1.0
• The flash output cannot be compensated in Green mode.
•
N
appears in the LCD panel and the viewfinder during Flash
Compensation. (p.26)
• If the maximum flash output is exceeded when corrected to the plus (+) side,
no compensation will be effective.
• Compensating to the minus (–) side may not effect the image if the subject is
too close, aperture is low or sensitivity is high.
• This flash compensation is also effective for external flash units which
support P-TTL auto flash mode.
- 0 . 7
0 . 7
- 0 . 7
F l a s h M o d e
F l a s h M o d e
F l a s h O n
F l a s h M o d e
F l a s h O n
O K
O K
O K
OK
