Pentax 17731, Operating Manual

Page: 142 / 280

140
3
Ta
king
Pi
ct
ures
In this mode, you can record multiple still pictures taken automatically at
a set interval from a set time, as a movie file.
1
Press the four-way controller ( 2 ) in
C
or mode.
2
Use the four-way controller ( 45 )
to select
k
(Interval Shoot) and
press the 4 button.
The current Interval Movie setting appears for
approximately one minute. To take pictures
with the current settings, go to step 10.
3
Press the 4 button while the settings are displayed.
The Interval Movie setting screen appears. [Interval] is marked with the
frame.
4
Set the interval.
1 Press the four-way controller (
5
).
A pull-down menu appears.
2 Use the four-way controller (
23
) to
set the interval, then press the 4
button.
The frame returns to [Interval].
5
Press the four-way controller (
3
).
Recording a Movie from Pictures Taken at a Set
Interval (Interval Movie)
Interval
You can set this to 1 minute, 5 minutes, 10 minutes, 30 minutes, or 1
hour.
Total Time
Set the total time, from 10 minutes to 359 hours. The total time and the
settable units change depending on the interval set. The Interval can
be set in increments of 1 minute, 5 minutes, 10 minutes, 30 minutes,
or 1 hour.
Start Delay
Set the start delay, from 0 minutes to 24 hours. The start delay can be
set in increments of 1 minute for a delay time up to 59 minutes, and
increments of 1 hour for a delay time longer than one hour. If the start
time is set to 0 minutes, the first picture is taken as soon as the shutter
release button is pressed.
OK MENU OK OK OK Cancel Cancel Cancel
Drive ve Mode
Interva val Shoot
Drive Mode
Interval Shoot
Interval Shoot
MENU
Interval 1min.
Total Time
Start Delay 0hr. 0min.
0hr. 10min.