Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
293 WRIGHT STREET, DELAVAN, WI 53115 WWW.PUMPS. COM
PH: 1-866-9 PENTEK ORDERS FAX: 800-426-9446
© 2017 Pentair plc. All Rights Reserved.
PN1047 (Rev. 04/06/17)
AA
Connecting to Gateway (Flashing)
Connected (Off)
Connection Error (Solid)
PENTEK
®
TRI-LARM
™
2
Log in to www.mylink2o.com to begin
installation.
Create a new account
Login and Add to an existing Account
-OR-
2b
2a
Device ID Label
After creating your account online, continue to step 3.
Install batteries (not included)
3
3a
3c
3b
3d
Unscrew cover.
Replace cover.
Review LED status.
Quick Start Guide
TM
with
When the LED turns off, installation is complete. If it is solid Red,
verify that the Gateway is in range and the Gateway shows a Green
LED. Remove and reinstall a battery to test connection
again.
1
This product
requires a Gateway
to connect to the
Internet. If a Gateway
has already been
installed for another
Link
2
O product, the
Tri-Larm will connect
automatically. If no
Gateway is present,
please install one
prior to setting
up the Tri-Larm.
ATTENTION:
Install batteries.
