Pentair SIATA V132-SFE-EV-VIRIDION, Installer Manual

Page: 61 / 110

Installer Manual Siata V132-SFE-EV-VIRIDION - Programming
Ref. MKT-IM-009 / C - 08.06.2018 61 / 110
6.4.3. Advanced programming
Entering the advanced menu
A Press and simultaneously for 5 seconds to access to the advanced menu.
B Enter the password.
→ See Access password, page 49.
Relays activation mode
Note

The number lit on the upper part of the display identifies the relay to set.
Select the relay.
A Set the relay 1 or 2 using or .
B Press to go through the parameter showed in the bellow table.
C For each parameter use or to change the value and to
confirm.
Parameter Description Characterisation
C1 1st regeneration cycle. OFF to duration of 1st cycle.
C2 2nd regeneration cycle. OFF to duration of 2nd cycle.
C3 3dr regeneration cycle. OFF to duration of 3rd cycle.
C4 4th regeneration cycle. OFF to duration of 4th cycle.
ri Active during whole regeneration. ON - OFF.
EC
Active from the end of regeneration
until the programmed time (minutes).
0 to 99 min.
SA Salt alarm. OFF - ON.
Fr Active if the alarm FR01 is present. OFF - ON.
AL Active in case of generic alarm active. OFF - ON.
B Active during refill.
OFF or rF (during refill) or rFd (during
refill & brine draw).