Installer manual Fleck 3150 NXT/NXT2 - Maintenance
Ref. MKT-IM-010 / C - 18.10.2019
147 / 182
9.4.8
Injector throat and washer cleaning
a) Using a 4 mm Allen wrench, unscrew (
1
).
b) Using a 24 mm wrench, remove the tube (
10
).
c) Using a 4 mm Allen wrench, unscrew (
11
) and remove the connector (
9
), the o-
ring (
8
) and the injector nozzle (
7
).
d) Using a 4 mm Allen wrench, unscrew (
5
) and remove the T-tube (
6
), the o-
rings (
3
and
12
), the injector throat (
4
) and the injector washer (
2
).
e) Clean the injector throat (
4
) and the injector washer (
2
) using compressed air, a
soft brush or possibly a pin.
f) Lubricate on the o-rings (
3
), (
8
) and (
12
) using silicone grease.
g) Reverse above procedure steps to rebuild.
Mandatory
The injector washers (
2
) have to be installed with their chamfered side upfront the
water stream flow. Flow indication must be visible after the injector washer (
2
) is
placed on the seat (
4
).
Summary of Contents for FLECK 3150 NXT
