P/N 474131
Rev. D 27-06-11
4
To identify the heater, see the data rating plate on the inner front panel of the heater. There are two designators for
each heater, one is the Model Number and the other is the Heater Identification Number (HIN).
Heater Identification Number (HIN)
The following
example
simplifies the identification system:
1)
MT
: MasterTemp
2)
Model Size
: (
200, 300
or
400
) : Input rating (Mega Joule [MJ]/hr)
3)
Construction
: (
HD
= Heavy Duty Model)
4)
Fuel Type
: (
LP
= Propane gas or
N
= Natural gas)
Section 1. Heater Identification Information
MT
3
00
HD
MT = MASTERTEMP
MODEL
S
IZE = MJ INPUT = Meg
a
Jo
u
le [MJ] / HR
H. I. N.
HEATER IDENTIFICATION NUMBER
ID DE
S
IGNATOR FOR PENTAIR WATER POOL AND
S
PA MA
S
TERTEMP HEATER
S
Example:
1
2
3
4
FUEL TYPE =
N = NATURAL
GAS
LP = PROPANE GAS
200 (200 [MJ] /HR), 300 (300 [MJ]/HR) or 400 (400 [MJ] /HR)
HD = HEAVY DUTY MODEL
N
Heater Identification Information (HIN)
Heater Data Rating Plate Location
The heater data rating plate is located on the inner front panel of the heater. To access the data rating plate, unbolt and
remove the side door access panel as shown below.
Heater Data Rating Plate
Door
Access
Panel
Top Panel
Remove this Door
Access Panel to access
the DATA RATING PLATE
LABEL P/N
INPUT RATE [MAX.] MJ/Hr
MODEL NO.
50 HZ
*SEE INSTALLATION MANUAL
240 VAC
DESIGNED AND MANUFACTURED BY
VOLTS
ORIFICE SIZE
ELECTRICAL RATING:
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
HERTZ
mm
Sanford, NC, USA 27330
THIS APPLIANCE MUST BE INSTALLED IN ACCORDANCE WITH THE AUSTRALIAN STANDARD AS5601-2004 INSTALLATION CODES, AND
WITH THE REQUIREMENTS OF THE AUTHORITY HAVING JURISDICTION.
AUS PH # +61 3 9574-4000
THIS HEATER EQUIPPED TO BURN GAS
THIS APPLIANCE HAS AN IPX3 RATING AND MUST BE INSTALLED
IN ACCORDANCE WITH THE AUSTRALIAN STANDARD AS/NZS 3000.
REFER TO THE OPERATING INSTRUCTIONS FOR APPROVED WATER TREATMENTS.
12 A
DO NOT INSTALL THIS HEATER UNDER AN OVERHANG
LESS THAN 1 METER FROM THE TOP. THE AREA UNDER
THE OVERHANG MUST BE OPEN ON THREE SIDES.
MasterTemp
™
AMPS
FOR YOUR SAFETY
APPROVED FOR OUTDOOR INSTALLATION ONLY.
ELECTRICAL COMPLIANCE: IN ACCORDANCE WITH
AS/NZS 3000.
SERIAL NO.
POOL HEATER
1620 Hawkins Ave.
MAX INLET GAS PRESS
6.0 kPa
MIN INLET GAS PRESS
1.0 kPa
TEST POINT PRESSURE
11±5 Pa
MAX WORKING PRESSURE
345 kPa
OUTPUT
kW
ALTITUDE
ELECTRICAL CERTIFICATE OF SUITABILITY NO.
MINIMUM THERMAL EFFICIENCY 76 PERCENT
MINIMUM CLEARANCE FROM COMBUSTIBLE
CONSTRUCTION, 15 cm SIDE, 15 cm REAR, 110 cm TOP
2000 m
GMK10016
AS4560
MT 400HDN
AUM4HDN 06/11/11 001
NATURAL
400
85.8
10.95 (NB)
