Installing PenMount 6000 Control Boards
9
2.3.
RS-232 & USB Boards (6000 Series)
All PenMount 6000 control boards use both RS-232 serial interface and USB interface
except 6300 which only supports USB connection. There are currently four models in the
6000 Series. The general procedure for board installation is similar, though hardware
connection and configuration varies for each board.
2.3.1.
Install PenMount 6200D Control Board
PenMount 6200D control boards are touchscreen control boards that use both
RS-232 and USB interfaces and supports 4-wire, 5-wire, and 8-wire
touchscreens. The size of the board is 62.0 x 33.0 mm and it has five
connectors and four dipswitches on-board. Follow the steps below to install
the 6200D control board.
1.
Cut off the power of your computer and display, then open the case of the
display or the system. Find space on your system and attach the control
board to your system with screws. The control board has industry
standard 3
φ screw holes.
2.
For the other installation details, see 2.2.1
on page 4:
6200D Control Board (for both RS-232 & USB Interfaces)
PenMount 6200D Touchscreen Control Board Upside
3.
Turn on the computer and the display. Install the software drivers and
utilities and calibrate the touchscreen. See
Chapter 3. Install Drivers for
