P
P
E
E
S
S
1
1
9
9
0
0
0
0
G
G
i
i
G
G
S
S
M
M
R
R
e
e
p
p
e
e
a
a
t
t
e
e
r
r
PES1900NR Operations Manual
Chapter 5. Installing the Growth Cabinet — 81
Installing the Power Cable
The Power Cable includes both AC and DC wiring, which are marked accordingly. Only one will be
used depending on the input power configuration of the repeater.
•
The AC wiring is 18-gauge (smaller size).
•
The DC wiring is 14-gauge (larger size).
The cable also includes two 1/2-inch flexible conduits.
If the cabinets are mounted horizontally, use the conduit marked
Horizontal
.
If the cabinets are mounted vertically, use the conduit marked
Vertical
.
1. While holding the cable that you will use, pull out the cable that you will not use.
2. Remove the Lock Nut from the connector at the Growth Cabinet end (the end with the
connector installed).
3. Thread the Power Cable up through the bottom of the entry box on the Growth Cabinet.
4. Replace the Lock Nut, and tighten it using channel-lock pliers.
5. Connect the Power Cable to the power socket, in the entry box of the Growth Cabinet, as
shown.
NOTE: Connect the cable so that the beveled or keyed corner is at the top right.
Figure 57 Growth Cabinet Power Connector