P
P
E
E
S
S
1
1
9
9
0
0
0
0
G
G
i
i
G
G
S
S
M
M
R
R
e
e
p
p
e
e
a
a
t
t
e
e
r
r
— Chapter 4. Mounting the PES1900GI NR
PES1900NR Operations Manual
44
Wall Mounting
Appropriate wall mounting hardware depends upon the type of wall to which the repeater is to be
mounted. For a typical wall mount installation, recommended equipment is as follows:
⇒
Four (4) lag bolts, hex-head, ¼ -inch to 5/16-inch or M8 hardware
⇒
Four (4) flat washers
⇒
Four (4) lock (split) washers
To mount the PES1900Gi NR on a wall:
1. Remove the security screws and washers and separate the rear-mounting bracket from the
Repeater.
2. Using the recommended hardware, secure the bracket to the wall—see the following figure.
Figure 9 Installation of Rear Mounting Bracket on a Wall
3. To set the repeater into the bracket, align the top of the repeater cabinet just above the top
mounting bracket, so that the mounting bracket will fit
inside
the left and right walls of the
repeater cabinet.
4. Slide the repeater cabinet downward, so that the guide bolt (on the repeater cabinet) slips into
the guide slot (on the mounting bracket).
5. Replace the security screws and washers removed in Step 1.