PelPro Pellet Stove • 8104-171B • 10/21
PelPro Pellet Stove • 8104-171B • 10/21
4
5
Getting Started
Getting Started
WARNING!
Inspect Stove and components for damage.
Damaged parts may impair safe operation.
•
Do NOT install damaged components.
•
Do NOT install incomplete components.
•
Do NOT install substitute components.
Report damaged parts to dealer.
Getting Started
Pallet Removal
There are bolts holding your PelPro Stove in place on the
pallet. To remove your Stove from the pallet:
What’s Included
Pallet Removal
Visit
or scan the code:
Owner’s
manual
Door handle
Cleaning tool
Outside air kit
components:
Power cord
2” Flex hose
Termination Cap
Hose clamp
Screws (4)
CAUTION!
Risk of cuts, abrasions or flying debris. Wear
protective gloves & safety glasses during install.
Metal edges are sharp.
Online Installation & Trouble
Shooting Videos
1
Loosen the three
retaining bolts on the
back of the Stove and
remove the right and
left side panels.
2
Using a 5/16 inch wrench,
on each side of the Stove
remove the two bolts.
Remove shipping brackets
by reaching into Stove in
the same area as the just
removed bolts.
APPAREILS À GRANULÉS
PP130 Appareil à granulés
Manuel du propriétaire
AVERTISSEMENT!
Veuillez lire entièrement ce manuel avant l’installation et l’utilisation de cet appareil d’ambiance à granulés, et conservez-le pour vous
y référer. Le non-respect de ces instructions risque de provoquer des dommages, des blessures, voire la mort. Communiquez avec les
responsables en bâtiment ou des incendies de votre secteur au sujet des restrictions et exigences d’inspection à l’installation de votre région.
Remarque :
To obtain a French translation of this manual, please contact your dealer or visit www.pelprostoves.com. Pour obtenir une
traduction française de ce manuel, veuillez communiquer avec votre détaillant ou visiter www.pelprostoves.com
Getting Started
What You’ll Need
Tools & Supplies
• High temperature silicone
(500°F+)
• Level
• Phillips screwdriver
• Plumb line
• Tape measure
•
Framing square
• Reciprocating saw
• Electric drill & bits
• Caulking gun
•
Stud finder
• Utility knife
• Pliers
• Flashlight
• Hammer
Safety Equipment
Recommended for all installation and maintenance steps.
Pellet Vent Pipe
Must be an approved 3” or 4” diameter Type “L” or “PL” vent. Use 4” diameter vent if flue height is over 15’ or if
installation is over 3,000ft. above sea level.
Gloves
Safety glasses
Close-toed shoes
Floor Protection
Non-combustible material
(such as a hearth pad) is
required underneath your
Stove.
Surge Protector
Protect the electrical
components of your Stove by
using a surge protector.
Pellet Fuel
Use only wood pellets in your
Stove. For best performance,
use premium, low-ash pellets
(<1%) less than 1.5” in length
and avoid the dusty bits and
pieces of pellets in the bottom
of the bag.
WARNING!
Fire Risk. NO OTHER vent components may be used. Substitute or damaged vent components may
impair safe operation.
