PV20a / PV30a pellet burner
page
4/ 41
DK9902A1 www.pelltech.eu
Safety
Do not start the burner before it is connected to the boiler and the boiler is connected to the
chimney.
When the burner is connected to the main power supply the burner casing must always be mounted.
Always make sure that the burner is unpluged from the main power supply before performing any
cleaning or maintenance.
Keep children away and do not touch the equipment during operation.
Make sure that no flammable or liquid materials are stored in the boiler room or vicinity of the
boiler.
It is recommended to wear a respirator while handling pellets.
The boiler room where the burner is installed must fulfill all rules and recommendations in
accordance with local codes and regulations.
All electrical installation, plumbing, chimney sweeping and service work shall be done by certified
and qualified personnel in accordance with local codes and regulations.
Warnings
Changing the construction of the burner without written permission from the manufacturer is
forbidden.
Use only spare parts provided or approved by the manufacturer in order to avoid any damage to the
burner and dangers resulting from it.
Welding is allowed only after disconnecting the burner from electric supply. The controller must be
removed from the burner before welding.
Do not open boiler door while the burner is in operation.
Notice
Manufacturer of burners has right to make changes in construction of burner and its firmware.
Present user manual is original user manual for PV20a and PV 30a pellet burners.
Pellet burners PV20a and PV30a correspond to following standarts and directives:
EN 15270 2008
EN 61000-6-2
EN 230 2005
EN 61000-6-3
EN 60335-1
EN 55014-1
EN 60335-2-102
2004/108/EC
EN 60730-1
2006/95/EC
EN 60730-2-5
2001/95/EC
EN 61000-6-1
2006/42/EC
