PELA 511068, Manual

Page: 8 / 14

3 Adjusment
The mains voltage and frequency of the power source must conform to the specifications of the
machine plate.
4 Instructions for use
4.1The tool is intended for use as a handheld tool. The tool can be used in any position. Note! The sanding tool
can develop a rotating reaction when started.
4.2 Make sure the tool is switched 'off'. Choose a suitable abrasive and attach it to the sanding pad. Make sure
that the abrasive is centered on the sanding pad. For optimal performance, we recommend original sanding
pad and sandpaper.
4.3 Switch on the tool by pressing the On / Off button, the LED is now red.
4.4 The tool can now be started by pressing the lever.
4.5 The speed can be set between 4000 and 10000 rpm + and rpm -. Each pressure increases or reduce the
speed by 1,000 rpm until it reaches the limits.
4.6 When sanding, always place the tool on the work surface before starting the tool. Always remove the tool
from the work surface before stopping it. This prevents erosion of the work surface due to excessive
speed of the abrasive.
4.7 Switch off the tool by pressing the On / Off button. The LED (right) is now off
5 Replace the sandning pad
Always disconnect the power before maintenance! Only use original sanding pads!
5.1 Insert the wrench between the sanding pad and break the seal holding the rethreader nut.
5.2 Rotate the sanding pad counterclockwise to remove it.
5.3 Mount and tighten the new sanding pad with washers.
5.4 Remove the key
Warning
Unauthorized voltage or frequency!
Risk of accident