VISION
100
THR
Page 6
USE AND MAINTENANCE MANUAL
Rev. 02-18
MAIN WARNINGS FOR THE INSTALLER
1.
Install the equipment in places complying with the protection degree and keep the box
as intact as possible when making holes to house the cable glands and/or conduit
glands;
2.
Avoid using multicore cables with conductors connected to inductive and power loads
and signal conductors which probes and digital inputs;
3.
Avoid housing power supply cables with signal cables (probes and digital inputs) in the
same conduit
4.
Reduce the lengths of the connection cables as much as possible, avoiding the wiring
assuming the spiral shape, damaging for possible inductive effects on the electronics;
5.
All conductors used in the wiring must be suitably proportioned to support the load to be
powered;
6
. Provide a main protection fuse upstream of the electronic control;
7.
If required to extend the probes, use conductors with suitable section and not below
1mm
²
. The extending or shortening of the probes may alter the factory calibration; use
an external thermometer to check and calibrate.
STANDARD EQUIPMENT FOR ASSEMBLY AND USE
For assembly and use, the electronic controller
VISION 100 THR
, is equipped with:
• N. 2 temperature probes;
• N. 1 telephone plug cable;
• N. 1 user manual;
• N. 1 Vision console (200VISIONTHR);
• N. 1 100N MASTER (200100NMSTH1);
CHAPTER 2: INSTALLATION
CHAP. 2 - Installation
2.1
2.2