www.Pegasustech.net
3 Parameter menus
3-1 Example: configure scanner
Important notes:
1. After each successful programming, the scanner will beep twice.
2. Throughout the programming barcode menus,
the factory default settings are indicated with
asterisks (*).
3. During the process of programming, LED is lighting to indicate the programming correctness. LED
will go off if any incorrect programming operation performed.
4. After each successful programming, LED will go off and the scanner will beep twice.
Two programming modes have been provided as bellows:
❶
Single-scan setting
Scan the appropriate
Single-scan setting
(e.g.
%0101D00%
) according to the user’s demand.
Example:
to set Flow control to be XON/XOFF.
Steps:
Scan the following barcode.
❷
Multiple-scan setting
The steps of configure scanner are:
1. Scan the
SETUP
bar code on the parameter setting part.
2. Enter the option mode by scanning the
Option bar code
.
3. To the right of the option barcode, the necessary alphanumeric inputs are listed. Scan these
alphanumeric entries.
4. Scan the
END
bar code, listed on the lower right hand corner of each parameter setting part.
5.
Notes that only one parameter can be setup at each time.
Example:
to set Flow control to be XON/XOFF.
Steps:
Scan the following barcodes in order.
SETUP bar code
SETUP
Single-scan setting
Option bar code
Option
Alpha. entry
Single-scan setting
Flow control
None
00*
RTS/CTS
01
(Host: Low RTS)
9
