E
LECTRICAL
I
NFORMATION
Combination Blanket/Fluid Warmer
▪
Operator’s Manual
▪
MN-39930
▪
Rev 2
▪
4/20
53
E
LECTRICAL
I
NFORMA
TION
Guidance and Manufacturer’s Declaration
The warmer requires special precautions regarding EMC (Electromagnetic
Compatibility) and needs to be installed and put into service according to the
EMC information provided in the accompanying documents.
Portable and mobile RF communications equipment can affect medical electrical
equipment.
A risk of increased emissions or decreased immunity may result if the power
cord is altered or a manufacturer supplied power cord is not used.
The warmer should not be used adjacent to or stacked with other equipment.
The essential performance of the warmer is to not exceed an internal
temperature of 160ºF (71ºC) for blanket warmers or 150ºF (66ºC) for fluid
warmers.
Electromagnetic
emissions
The warmer is intended for use in the electromagnetic environment specified
below.
Continued on next page
Emission test
Compliance
Electromagnetic environment - guidance
RF emissions;
CISPR 11
Group 1
The warmer uses RF energy only for internal
function. Therefore, its RF emissions are very
low and are not likely to cause any interference
in nearby electronic equipment.
RF emissions;
CISPR 11
Class B
The warmer is suitable for use in all
establishments, including domestic
establishments and those directly connected to
the public low-voltage power supply network
that supplies buildings used for domestic
purposes.
Harmonic
emissions; IEC
61000-3-2
N/A
Voltage
fluctuations/Flicker
emissions; IEC
61000-3-3
N/A
Summary of Contents for P-2147
Page 1: ...Operator s Manual Combination Blanket Fluid Warmer P 2147 P 2150 MN 39930 REV 02 4 20 EN...
Page 58: ......
Page 59: ......
