Peavey MediaMatrix Nion, Hardware Manual

Page: 63 / 94

NION Hardware Manual
September 30, 2010 Version 1.6.1.0 59
5. Press Enter.
To specify a static IP address
1. Type
setenv dhcp no
and press Enter.
2. Type
setenv ipaddr <IP address>
and press Enter.
3. Type
setenv netmask <subnet mask>
and press Enter.
4. If you want the settings to be saved and used each time the NION boots, type
saveenv
and
press Enter.
If you omit this step, the settings will only be used for the current session.
5. Type
boot
and press Enter.
To specify an IP address automatically using DHCP
1. Type
setenv dhcp yes
and press Enter.
2. If you want the settings to be saved and used each time the NION boots, type
saveenv
and
press Enter.
If you omit this step, the settings will only be used for the current session.
3. Type
boot
and press Enter.
Some examples
Scenario Command to use
The NION is configured with a static IP
address, but you want to assign a new
address that is temporary.
setenv ipaddr 10.1.10.100
setenv netmask 255.255.0.0
boot
You want to use DHCP for this session and
each time the NION boots.
setenv dhcp yes
saveenv
boot
You want to use a static IP address for this
session and each time the NION boots.
setenv dhcp no
setenv ipaddr 10.1.10.100
setenv netmask 255.255.0.0
saveenv
boot
Front panel LED indicators
There are several LEDs on the NION front panel that help indicate unit status.
Fault
RED Audio not working.
OFF Audio working.