Peavey Max 160, Operation Manual, Page: 5 / 28

((11)) R RE EM MO OV VA AB BLLE E A AC C P PO OW WE ER R C CO OR RD D
This receptacle is for the IEC line cord (included), which provides AC power to the unit. Connect the line cord to
this connector and to a properly grounded AC supply. Damage to the equipment may occur if an improper line
voltage is used. (See voltage marking on unit.) Never remove or cut the ground pin of the line cord plug. This unit
is supplied with a properly rated line cord. When lost or damaged, replace this cord with one of the proper
ratings.
N NO OT TE E:: FFO OR R U UK K O ON NLLY Y
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow must be
connected to the terminal which is marked by the letter E, or by the earth symbol, or colored green or green and
yellow. (2) The wire which is colored blue must be connected to the terminal which is marked with the letter N, or
the color black. (3) The wire which is colored brown must be connected to the terminal which is marked with the
letter L or the color red.
((2 2)) P PO OW WE ER R S SW WIIT TC CH H
Used to turn AC mains power on or off. Place the switch in the (ON) position to turn the unit on.Return it to the
(OFF) position to turn the unit off. The Status/Power LED (22 ) on the front of the unit will illuminate green to
indicate the unit is on.
((3 3)) FFU US SE E
The fuse is located within the cap of the fuseholder. If the fuse should fail, IT MUST BE REPLACED WITH THE
SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT VOIDING THE
WARRANTY. If the unit repeatedly blows fuses, it should be taken to a qualified service center for repair.
W WA AR RN NIIN NG G:: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN DISCONNECTED FROM ITS
POWER SOURCE.
C CA AU UT TIIO ON N:: USING A FUSE LARGER THAN THE RECOMMENDED SIZE COULD RESULT IN PERMANENT DAMAGE TO
THE AMPLIFIER.
((4 4)) S SP PE EA AK KE ER R JJA AC CK KS S
Two paralleled 1/4" speaker jacks are provided for connection to speaker enclosures. The minimum speaker load
impedance is 4 Ohms.
5
R Re ea arr P Pa an ne ell
1 3
2 4