Introduction
Tools
Before you begin
Fixtures
Shower
Thank you for purchasing an authentic Pearl® shower set. Crafted out of the
highest quality nickel and brass, each and every fixture component is tested
and carefully inspected by hand before leaving the factory.
Please read the instructions carefully to prevent malfunction and/or
damages to your plumbing and property.
Diverter Mounting
1.
Turn off
all water supply lines and
drainage lines.
2.
Clean the installation area
thoroughly and remove any excess
debris.
3.
Secure the diverter
1 3/8”
back from
the face of the stud, mounted on a
crossbeam.
(Figure i)
4.
Connect the diverter to the water
supplies using appropriate fittings. An
adaptor may be needed depending on
your piping. (
Figure ii
)
5.
Depending on your model, connect
the shower head, hand shower, and
spout piping to the diverter. (
Figure iii
)
6.
Finish the surrounding area before
proceeding to complete the diverter
installation.
7.
Mount the cover plate to the
diverter. (
Figure iv)
8.
Install the handles and switches
with an allen key. (
Figure v
)
9.
Please continue to the testing
section on the back side of this manual.
The tools below may be needed to complete the installation. They are not
absolutely required, but having them will greatly assist in the installation
process. For additional information, check with your local hardware store on
the requirements for your installation.
•
Read all instructions carefully before beginning installation.
•
Assemble all the tools you might need.
•
Flush both hot and cold water lines before proceeding with installation.
•
Turn off main water supply before removing old fixtures.
•
Clean surfaces and work area before installing new fixtures.
•
Cover openings or drainage to prevent small parts from getting lost.
•
Cleaning with any chemical substance will void the limited warranty.
•
For the best results we always recommend that the installation be
performed by a licensed professional.
Helpful Hint:
Always use Teflon® tape or
other thread sealing tape on
water supply connectors to
prevent leaking. Do not use
plumber’s putty or oil-based
sealant. We recommend
silicon caulking for sealing
drain flange and other parts.
Philips Screwdriver
Allen Hex Key
Channel Locks
Adjustable Wrench
Thread Seal Tape
Pliers
Flathead Screwdriver
Flashlight
Figure ii
Figure i
Figure iii
Figure iv
Figure v
Triple Diverter Model
Triple Diverter Model
Model Shown: ETHAN
Model Shown: ETHAN
Safety Glasses
Hot
Cold
1 3/8”
crossbeam
face of the stud
P e a r l S i n k s . c o m
