Vendor Item # FB0016BA
Target DPCI #: 084 09 3270
Description: S&H Bathtub Fountain
Questions, Problems, Missing Parts?
Before returning to your retailer,
PLEASE CALL CUSTOMER SERVICE at
(866) 728-6187
9am – 5pm EST, Mon – Fri or e-mail
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged parts.
If any parts are missing or damaged, do not attempt to assemble or use the product. Please contact customer service for replacement.
CARTON CONTENTS:
Part# Description
Quantity
01. Ornament 1
1
02. Ornament 2
1
03. Top fountain
1
04. Screw
2
05. Washer
2
06. Water supply tube
1
07.
08
09.
Cover
Pump
Basin
1
1
1
TOOLS REQUIRED FOR ASSEMBLY:
z
Screwdriver (Not included)
FOUNTAIN ASSEMBLY INSTRUCTIONS:
1.
Unpack the contents of the box and check to make sure that all
items are accounted for and in good condition.
2.
Select a flat, level surface for the assembly and final location of your fountain.
3.
Place the basin on a flat, level surface and place the pump into the pump housing of the basin. Run the pump power cord out through the middle hole on
the basin back wall and up and out of the cord slot (Fig1)
4.
Insert one end of the water supply tube (the hard tube end) into the hole on the underside of the top fountain and run the other end out through the middle
hole of the basin to the pump housing. Align the mounting holes of top fountain with the screw holes on the basin top and place the top fountain onto the
basin. Use the two screws and washers to secure the top fountain to the basin. (Note: draw the pump power cord out from the cord slot at the back of the
top fountain. (Fig 2)
5.
Insert the water supply tube into the pump outlet and place the cover over the pump housing to hide the pump. Insert two ornamental little birds into the
matching holes on the fountain top. (Fig 3)
6.
Add clean water into the basin. The water level should be approx 30mm below the top edge of the basin.. (Fig 4)
7.
Connect the pump power cord to a GFCI outlet. The product will begin to function as intended. Gently sweep across the water surface to achieve even
water flow. (Fig 4)
8.
To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing after the initial setup of your fountain. It is
highly recommended that this fountain be placed in an area that will not be damaged should the area come in contact with liquid.
9.
Do not leave your fountain running for extended periods of time when no one is present to observe the performance.
9.
Check the area around your fountain on a regular basis to ensure that there is no leakage.
NOTE:
The diagrams shown are for illustrative purposes only and are not to scale.
