PCAN-Router Pro – User Manual
22
3.5
Power Supply via D-Sub Connector
As an alternative to the power connector intended for supplying the
PCAN-Router Pro, it can be supplied via pin 9 of the D-Sub
connector
CAN 3
or
CAN 4
with 8 to 27 V DC. On the circuit board of
the PCAN-Router Pro, a connection to the desired D-Sub connector
must be established with a solder bridge. Pin 6 (GND) is used as
negative for the supply.
Do the following to enable the supply via a D-Sub connector:
Danger of short circuit!
Take great care when soldering to
avoid short circuits.
Attention!
Electrostatic discharge (ESD) can damage or destroy
components on the circuit board of the PCAN-Router Pro. Take
precautions to avoid ESD when handling the circuit board.
1.
Disconnect the power supply.
2.
Unscrew the four screws along the top edges of the housing
on the front and back of the device.
3.
Remove the housing cover.
4.
Unscrew the two screws at the lower corners of the front
cover.
5.
Together with the front panel, pull out the circuit board into
front direction from the casing's lower part.
6.
Solder the solder bridge(s) on the board using the following
figure and table: