H² Detector
User Manual
Page 16
2013 © Peak Scientific – Rev 4 – 03/09/1
Electrical Connection
Connect the Detector to the Peak Scientific Precision 500 Generator using the
communication cable provided.
This unit is plugged, from the ‘In’ port at the rear on the detector, into the ‘H
2
Detector’ port at the rear of the generator, as shown below. This connection
will provide the detector unit with power and allows communication between
the Precision 500 and the detector unit.
The detector will take samples continuously and both the detector and the
Precision 500 will alarm if dangerous levels of hydrogen are detected, the
Precision 500 will then shut down.
Multiple detectors can be connected to one Precision 500. If this is desired,
connect the first detectors ‘Out’ port to the second detectors ‘In’ port, as
illustrated below. Please take into consideration when working with multiple
Hydrogen Detector Units that a minimum required distance between units is
82mm (3.23in).
H
2
Detector
Port
In Port
Out Port
Precision 500
H
2
Detector
