Page 16
Drain Connection
Fit the 6mm push fit fitting to the drain port located on the output panel. Tighten
using a 16mm or 5/8” spanner. Use the 6mm tubing to connect this to a suitable drain
connection or container. It should be noted that the Generator can expel a considerable
amount of water from this (dependant on ambient humidity).
If a container is used it should be emptied at regular intervals. The
container must NOT have an air tight seal as water and air are expelled
at pressure.
When using this drain bottle, please note below recommendations:
1. A drain bottle should only be connected 1:1 to a single Peak Generator
2. The bottle should not be allowed to be filled with drain water to more than 2/3rds
3. The vent size should not be blocked or restricted in any way.
CAUTION
Summary of Contents for Genius XE SMZ
Page 1: ...Genius XE SMZ User Manual Rev 1 RSID 4041 EN 09 02 21 Genius XE SMZ User Manual...
Page 30: ...Page 30...
Page 31: ...Page 31...
