22
Cyclone for ARM devices User Manual
Cyclone for ARM
®
devices
Figure 3-17: Ribbon Cable Diagram When Looking Into IDC Socket
3.14
Target Power Management
The Cyclone for ARM devices provides four power management schemes.
The target board may derive power by the use of the power jacks, by the use
of the debug connector TVCC pin, or a combination of both. The options are
explained in detail below. Each configuration will have an associated jumper
setting that MUST be set on the Cyclone for ARM devices. The jumper header
is found on the long front side of the unit, directly to the left of the Target
Power In and Out jacks.
