PowerWave 2 Bus System BCMS Setup and Operation
6
Safety
Please pay special attention to the use of “Danger” symbols throughout this manual indicating electrical
or other safety hazards. Following these safety instructions is extremely important to avoid possible
injury or death.
DANGER!
This symbol is used throughout this manual to indicate the presence of high voltages,
representing a hazard for electric shock, burn or explosion. Follow the instructions
carefully to avoid serious or fatal injury.
Follow safe electrical work practices:
•
Read, understand, and follow the instructions before installing this product.
•
Disconnect and lock-out all power supplying equipment before working on or installing
PowerWave 2 Bus System components, including the Branch Circuit Monitoring System.
Use a properly rated voltage sensing device to confirm power is OFF. However, Tap Off
Boxes can be inserted into an operational Bus System, if the Bus System has been tested and
certified.
•
Install equipment in an appropriate electrical environment per local regulations.
•
PCBs are ESD sensitive equipment. Ground yourself, discharge any static charge and ensure
that the device is effectively grounded before handling the unit.
Electrical equipment should be installed, operated, serviced, and maintained only by qualified personnel
and in accordance with all local safety codes. Power Distribution, Inc. assumes no responsibility for any
consequences arising out of the use of this manual.
This document should not be viewed as sufficient
by otherwise non-qualified personnel to operate, service, or maintain the equipment discussed.
