background image

Communication  
Systems Inc.

PDI-P23LCDD Quick Start Guide 

Page 1 of 8 

Better Solutions Are Within Reach™ 

INSTALLATION INSTRUCTIONS

PDi Communication Systems, Inc.   40 Greenwood Lane   Springboro, Ohio 45066 USA   PH +1-937-743-6010  PH +1-937-743-5664  

Document Number:  PD196I148R1.DOC 

PRODUCT ACCESSORIES 

(Not Included with TV) 

100mm VESA Wall Mount

PD168-003 

Programming Remote 

PD108-420 

Patient Remote 

PD108-421 

¼” to 6-Pin Jumper Cable

PD106-416 

¼” to ¼” Jumper Cable 

PD106-417 

WARNINGS

CAUTION :  

To reduce the risk of electric shock do not 

remove cover (or back). No user serviceable parts inside. Refer 
servicing to qualified service personnel. 

This symbol is intended to alert the user of the 
presence of uninsulated ‘dangerous voltage’
within the product’s enclosure that may be of 
sufficient magnitude to constitute a risk of electric 
shock to persons. 

This symbol is intended to alert the user of the 
presence of important operating and maintenance  
(servicing) instructions in the literature 
accompanying the appliance.

OVERHEAD FALLING HAZARD 

WARNING: To prevent injury, this apparatus 
must be securely attached to the wall in 
accordance with the installation instructions.  TVs 
can pose a striking hazard when mounted at an 
elevated position.

RAIN AND MOISTURE 

WARNING: To avoid the hazards of fire or 
electrical shock, DO NOT expose this television 
to rain or moisture.

OXYGEN ENVIRONMENT 

WARNING: Do not use in any oxygen tent or 
oxygen chamber. Such use may cause a fire 
hazard.

RAIN AND MOISTURE 

WARNING: To avoid the hazards of fire or 
electrical shock, DO NOT expose this television 
to rain or moisture.

WET LOCATION 

Apparatus shall not be exposed to dripping or 
splashing and no objects filled with liquids, such 
as vases, shall be placed on the apparatus.

PRODUCT MODIFICATION 

Do not attempt to modify this product in any way without written 
authorization. Unauthorized modification could void the user’s 
authority to operate this product.

NOTE TO CABLE TV INSTALLER 

This reminder is provided to call the cable TV systems 
installer’s attention to Article 820-40 of the National Electrical 
Code. The code provides guidelines for proper grounding 
and, in particular, specifies that the cable ground shall be 
connected to the grounding system of the building, as close 
to the point of the cable entry as practical. 

FCC Information 

This device complies with Part 15 of the FCC Results. 
Operation is subject to the following two conditions: 

(1) This Device may not cause harmful interface, and  
(2) This device must accept any interference received, 

including interference that may cause undesired 
operation.

Notice

 : This equipment has been tested and found to 

comply with the limits for a Class B digital device, pursuant 
to part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference 
when the equipment is operated in a residential or 
commercial installation. If this equipment does cause 
harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the 
user is encouraged to try to correct the interference by one 
of more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and 
receiver.
• Connect the equipment into an outlet on a circuit different 
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician 
for help. 

Warning

 : Change or modifications not expressly approved 

by the manufacturer could void the user’s authority to operate 
the equipment. 

MAINTENANCE AND SERVICING 

Never remove the back cover of the TV; this can expose you 
to high voltage and other hazards. If the TV does not 
operate properly, unplug it and call an authorized service 
center or PDI. 

CLEANING AND DISINFECTION 

Clean the exterior of this television by removing dust with a 
lint-free cloth. CAUTION: To avoid damage to the surface of 
the television, do not use abrasive or chemical cleaning 
agents. 

DISCONNECTING DEVICE FROM MAINS 

Main plug is the disconnecting device.  The plug must 
remain readily operable. 

SERVICE INSTRUCTIONS 

CAUTION: These servicing instructions are for use by 
qualified service personnel only.
To reduce the risk of electric shock, do not perform any 
servicing other than contained in the operating instructions 
unless you are qualified to do so. 

Summary of Contents for PDI-P23LCDD









Reviews: