Pco ultraviolet, User Manual

Page: 45 / 53

45
A1 TECHNICAL DATA
A1.6 REAR PANEL
USB
2.0 plug
Power socket :
Input: 9…28V; max. 3W
RJ 11 connector
Pinout of RJ11 connector
Pin Description
1 GND
2 Exposure out (TTL 3V)
3 Busy out (TTL 3V)
4 not used
5 Trigger in (TTL 0…5V)
6 +12V (alternative power supply)
Pin Position
Timing & Signals
busy = TRUE / high camera is recording or sensor
readout in progress
busy = FALSE / low external trigger is ready to accept
exposure = TRUE / high exposure of image sensor
In
Auto Sequence
trigger mode the busy signal is always set to
TRUE, while the exposure signal indicates the real exposure of the
image sensor.
In
External Exp. Start trigger mode the camera is ready to accept a
new trigger signal on PIN #5 (trigger) when the busy signal is set to
FALSE. After a successful trigger event the busy signal stays TRUE
until the exposure is finished and the image is completely read out.
1 2
3
1
2
3
Pin 1