© PCE Instruments
4
4
Operation
5.1 Switching the meter on and off:
•
Press the on/off key (6) to switch on the unit.
•
After approx. 20 s without use, the device switches off automatically.
•
Press the on/off key (6) to switch off the unit.
5.2 Measurement
•
Apply approx. 1-2 cm reflective tape to the test object that is not yet rotating.
•
A bright environment has a negative effect on the reflection and the measurement
result. Therefore, if necessary, shade the area to be measured and avoid direct
sunlight.
•
For a measurement, press the measuring/trigger key (2) and point the laser at the
rotating object.
•
Be careful!
Rotating components are dangerous!
5.3 Hold function
•
The instrument automatically switches to the hold function after the measurement.
5.4 Max/Min/Avg measured value
•
Press the Max button (8) once to read the maximum value of the measurement.
•
Press the Max button (8) twice to read the minimum value.
•
Press the Max button (8) three times to read the average value (AVG).
5.5 Switching the backlight on and off
•
Press the backlight key (5) to switch on the display backlight.
•
Press the backlight key (5) again to switch off the display backlight.
5.6 Auto measurement function
•
Press the auto key (7) to start an automatic measurement. Press the key again to exit
Auto mode.
•
Note
: The laser is permanently active in auto mode, the trigger key (2) does not need
to be pressed.
5.7 Recording function
•
In Auto mode, press the REC key (9) to start recording.
•
A maximum of 60 measured values can be stored.
•
Press the REC key (9) again to pause the measurement.
5.8 Measuring interval in recording mode
•
Press and hold the REC key (9) and turn on the power to set the recording interval.
•
While holding down the REC key (9), press the backlight key (5) to decrease the interval
time or the auto key to increase the time.
•
The time interval can be set from 1-99 s.
