PCD UK01, User Manual

Page: 7 / 23

UK01 User manual
6
take some time before the charging indicator appears on the screen;

When the battery indicator icon is displayed on the screen is full, and
no longer flashing, indicates that the charge has been completed.

During charging, batteries, cell phones and chargers may have a fever, is a normal
phenomenon;

After charging is completed, disconnect the AC power outletand mobilephone
charger.
Note: The phone battery charge approximately 50% of capacity, which can be used apart.
Completely filled in and then run
out of the first completely; fully charged and then have to
completely run out of second, which requires three consecutive cycles, the battery is easy to
achieve the best use of the state.
Four. Quick Start Guide
1. Calling features

When the network provider's logo appears on the display, you can call or answer the
phone

Three interfaces: dial, caller ID and call this function;

Display the upper-left corner of the information bar shows the network signal
strength.

The call quality by the impact of obstacles, so the move in a small area can effectively
improve the signal strength.
Note:

In any country using the digital GSM network, if you are in the network coverage area
(you can check the phone display network signal strength indicator in the upper left
corner learned), you should be able to use the call function.

If your network provider does not provide roaming services in the region, will be
displayed on the display "can make emergency calls (Emergency)", to tell you that only
such call.

If you are in network coverage, even without a SIM card to make emergency calls.
1.1.
Call
Click the dial-up icon, enter the dial-up interface
Press the number keys, enter the phone number
Press the dial key to call
Press the end key to end the call.
1.2. An incoming call
New calls when the phone non-standby, press the dial answer button Or the side buttons to
answer the call; reject a call press the end hang up button
Description:
Insert the headset, you can use the headset key to answer.
1.3.
call options
During a call, Press the "Options" button on the right soft key to enter the call options.
In the call option, you can proceed as follows:

Show dialpad