DXP-3800D
- 14 -
●
Status
●
Config
●
System
After go into every sub-menu, you can press LEFT or RIGHT to move the cursor, then use UP or
DOWN to change the value, and then you can press ENTER to make the selection.
Submenu Name
Description
Status
Monitor the parameters of Tuner RSSI, Input Bitrate, Output Bitrate, TS over
IP input (only when the TS/IP streaming board is installed) information.
Config
Configure the parameters of Tuner setting, CI settings, BISS setting, Remux
setting, ASI output and so on.
System
Check and set system settings and read the equipment information, and
make the default factory setting and so on.
5.1.3 Configuration Menu
In the
Configuration
menu, user can configure and monitor the parameters of input and output,
including Tuner, CI settings, AV decoder, ASI output, BISS, SDI, TS over IP input (only when the
TS/IP streaming board is installed) and so on. Choose
Configuration
and press UP or DOWN to
scroll the sub-menus, press ENTER to go into the sub-menus. There are ten sub-menus to configure:
●
Slave Board Setup (Tuner1~8 setting)
●
CI
●
BISS
●
Remux
●
TS/IP
●
ASI Out
Submenu Name
Description
Slave Board Setup
Tuner
Tuner-1
Tuner-2
Tuner-3
Tuner-4
Tuner-5
Tuner-6
Tuner-7
Tuner-8
LNB LO
Frequency
To configure the local oscillator frequency
according to the right satellite, its range is from
5150 to 11,300MHz.
Satellite
Frequency
To configure the satellite down link frequency
according to the right satellite, its range is from
1000 to 26,500MHz.
Symbol Rate
To configure the symbol rate of QPSK signal, its
range is from 1000 to 45,000KBaud.
LNB Voltage
To select the correct LNB voltage output from the
F-connector, user can choose between Off, 13V
and 18V.