en
65
13 SD card
The controller is equipped with an SD card slot for SD memory cards.
With an SD card, the following functions can be carried out:
• Logging measurement and balance values. After the transfer to a computer, the
values can be opened and visualised, e. g. in a spreadsheet.
• Store adjustments and parameterisations on the SD card and, if necessary, re-
trieve them from there.
• Running fi rmware updates on the controller.
Firmware updates
The current software can be downloaded from www.resol.de/fi rmware.
When an SD card with a fi rmware update is inserted, the enquiry Update? is in-
dicated on the display. The setting can be changed between Yes and No by pressing
buttons
❷
and
❹
.
Î
To run the update, select Yes and confi rm by pressing button
➄
The update is run automatically. The indication Please wait and a progress bar
appear on the display. When the update has been completed, the controller will
automatically reboot and run a short initialisation phase.
Î
To skip the update, select No.
The controller commences normal operation.
Note:
The controller will only recognise a fi rmware update fi le if it is stored in
a folder named SC514 on the fi rst level of the SD card.
Î
Create a folder named SC514 on the SD card and extract the down-
loaded ZIP fi le into this folder.
Starting the logging
Î
Insert the SD card into the slot
Î
Adjust the desired logging type and interval
Logging will start immediately.
Stopping the logging
Î
Select the menu item Remove card...
Î
After Remove card is displayed, remove the card from the slot
When Linear is adjusted in the Logging type adjustment channel, data logging
will stop if the capacity limit is reached. The message Card full will be displayed.
When Cyclic is adjusted, the oldest data logged onto the SD card will be overwrit-
ten as soon as the capacity limit is reached.
Note:
Because of the increasing size of the data packets, the remaining logging
time does not decrease linearly. The data packet size can increase, e. g.
with the increasing operating hours value.
Storing controller adjustments
Î
To store the controller adjustments on an SD card, select the menu item Save
adjustments.
While the adjustments are being stored, fi rst Please wait, then Done! will be
indicated on the display. The controller adjustments are stored as a .SET fi le on
the SD card.
Controller adjustments, loading of
Î
To load controller adjustments from an SD card, select the menu item Load
adjustments.
The File selection window is indicated.
Î
Select the desired .SET fi le.
While the adjustments are being loaded, fi rst Please wait, then Done! will be
indicated on the display.
Summary of Contents for SC5.14
Page 78: ...en 78 ...
Page 79: ...en 79 ...
