Ethernet
50
SmartNode 5530 User Manual
C
• Cabling
Ethernet
Ethernet devices (10/100/1000 Base-T) are connected to the SmartNode over a cable with RJ-45 plugs. All
Ethernet ports on the SN5530 are Auto-MDX. Use any straight or crossover cable to a host, hubs, switches,
PCs or other devices.
Note
Connecting both Ethernet ports to the same switch will only work is the
switch has separate ARP table for each connection.
Figure 10. Typical Ethernet straight-through cable diagram for 10/100Base-T
Figure 11. Typical Ethernet straight-through cable diagram for 1000Base-T
The interconnecting cables shall be acceptable for external use
an shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
For the ISDN connection to a carrier network, it shall be con-
nected to a network termination device and not connected
directly to an outside POTS line.
CAUTION
CAUTION
RJ-45, male
1
2
3
6
RJ-45, male
1
2
3
6
Switch or Hub
Straight-through cable
Note: Other pins are not used
12V, 1A
BRI 0/3
BRI 0/2
BRI 0/1
BRI 0/0
ETH 0/0
USB
Console
Reset
ETH 0/1
RJ-45, male
1
2
3
4
RJ-45, male
1
2
3
4
5
6
7
8
5
6
7
8
