Power Requirements and Mounting
23
FiberPlex FP1004E User Manual
2
• Installation
Figure 11. FP1004E installation on a TD-DINR
Tray Mounting
Complementing the flexibility of the FiberPlex TD Series of fiber optic modules, the TDR-01-AC provides
mounting, power and cable management for up to 3 FP1004E modules in a compact and rugged aluminum
1U rack (see
on page 24). The integrated key-hole mounting holes on the bottom the TD units lock
securely on mating studs while a rear retention bar holds them securely in place. A 6 position wiring harness and
included power adapter provide, not just 9 VDC power, but a positive earth ground to the modules via 3 posi-
tion Phoenix™ locking power connectors. Managing all that cabling and fiber can sometimes be quite a chore so
an extended cabling tray with integrated tie down points are provided to help make your installation clean.
Note
The TDR and TDP trays use a 9 VDC 30W (3.5A) power adapter. When 3
FP1004E are used in the same rack, certain SFP populations could exceed
30W. Please carefully check your configuration against the specification table
to verify your power consumption.
