Basic System Management Configuration Task List
81
CopperLink CL2300 User Manual
10
• Basic System Management
device#reload
System configuration has been changed.
Press 'yes' to restart, 'no' to cancel: yes
The system is going down
Displaying the System Logs
The system logs contain warnings and information from the system components of Trinity3. In case of prob-
lems it is often useful to check the event or the supervisor logs for information about malfunctioning system
components. The event log stores general events such as flash full, DSP failed etc., comparable with the event
log on Windows NT. The supervisor log stores information from the system supervisor such as memory full,
task failed etc.
System resets may have a number of reasons, the most prominent being a manual reset issued on the Telnet/
console (‘reload’). Other reset reasons include power off failures and system failures. In order to pinpoint the
problem, the reset log contains the reset cause.
Mode:
Administrator execution
Step
Command
Purpose
1
device
#show log event
Show event log.
2
device
#show log supervisor
Show log of the system supervisor. Used For example, after an
unexpectedly reboot.
3
device
#show log reset
Output a list of reset reasons (with date and time).
4
device
#show log boot
Displays the console and log messages captured during startup of
the unit.
Displaying Reports
The show reports command is used to dump combined system information. The show reports command
sequentially executes the following log commands:
show version
show clock
show uptime
show log reset
show log boot
show log event
show log supervisor
show factory-config
show startup-config
show running-config
Mode:
Administrator execution
Step
Command
Purpose
1
device
#show reports
Dumps the combined system information.