Dial In Modify window
79
Access Server Administrators’ Reference Guide
7 • Dial In
•
enableBell212(2)—Enable Bell 212 modulation
V21(diModemV21Enable)
Allow V.21 or Bell 103 modulations. The following options are available:
•
disable(0)—Neither option is enabled
•
enableV21(1)—Enable V.21 modulation
•
enableBell103(2)—Enable Bell 103 modulation
MaxSpeed (diModemMaxSpeed)
This variable assigns the fastest data rate that will be negotiated. The range is 300–64000.
MinSpeed (diModemMinSpeed)
This variable assigns the slowest data rate that will be negotiated. The range is 300–33600.
Note
Increasing this number may prevent users with slower modems from
successfully connecting.
Guard Tone (diModemGuardTone)
Normally a guard tone is not required, but one can be inserted. This setting works for Phase Shift Key (PSK)
modulations only, not for V.32 or V.34.
•
tone None(1)—Guard tone is not used
•
tone1800(3)—Guard tone is enabled
CarrierLossDuration (diModemCarrierLossDuration)
The number of 100ms intervals that the carrier signal must be missing before the connection is considered lost.
Choosing a setting of 255 indicates forever. The range is 1 to 255.
Billing Delay (diBillingDelay)
The number of seconds after answering the call during which the modem should remain silent.
Retrain (diModemRetrain)
Enables the modem to monitor line quality and request a fallback or retrain for poor quality and a fall forward
for good quality.
•
none (0)—Do not allow modem to retrain, fallback, or fall forward.
•
retrain(1)—Allow the modem to retrain if the line quality is poor.
•
FallForwardFallBack(2)—Allow the modem to fallback to a slower speed if the line quality is poor, or fall
forward to a faster speed if the line quality is good.
TxLevel (diModemTxLevel)
This variable should be set with caution; and normally only after talking to a factory representative. This sets
the transmit level power level of the modem. The scale is 12 (-12 dB) to 20 (-20 dB) in 1 db increments.
Summary of Contents for Access Server
