EN
120
EN
121
wheel may bind, walk up or kickback if the
power tool is restarted in the workpiece.
e)
Support panels or any oversized work-
piece to minimize the risk of wheel
pinching and kickback.
Large workpieces
tend to sag under their own weight. Sup-
ports must be placed under the workpiece
near the line of cut and near the edge of the
workpiece on both sides of the wheel.
f)
Use extra caution when making a “pock-
et cut” into existing walls or other blind
areas.
The protruding wheel may cut gas or
water pipes, electrical wiring or objects that
can cause kickback.
ADDITIONAL SAFETY INSTRUCTIONS ON
RISKS DUE TO VIBRATION
a)
The declared vibration data represents
the main applications of the tool, but
different uses of the tool or poor main-
tenance can result in different vibration
data.
This may significantly increase the
vibration level over the total working period.
b)
Additional safety measure shall be taken
to protect the user from effects of vibra-
tion.
Maintain the tool and its accessories,
keep hands warm and organize work pat-
terns and periods.
Noise & Vibration
The values given in these instructions have
been measured in accordance with a stand-
ardized measurement procedure specified in
EN 60745-1 and EN 60745-2-3 and can be
used to compare tools. It may be used for a
preliminary assessment of exposure.
Warning!
The vibration emission
during actual use can differ from the
declared total value depending on the use
of the tool.
The values given are valid for nominal voltages of 230 V. For lower voltage and models for spe-
cific countries, these values may vary.
Please observe the article number on the type plate of the tool. The trade names of the individual
tool may vary.
Technical Data
Nominal voltage
230-240V~ / 50 Hz
Rated power
1200 W
Rated speed (n)
11500/min
Max. size of wheel
ø 125 mm
Spindle size
M14
Weight
4.0 kg
Protection Class
/ II
Sound pressure level (L
pA
)
85.3 dB(A) / Uncertainty K = 3.0 dB(A)
Sound power level (L
wA
)
103 dB(A) / Uncertainty K = 3.0 dB(A)
Max. vibration emission (a
h,AG
)
6.9 m/s
2
/ Uncertainty K = 1.5 m/s
2
Intended use
The tool is intended for cutting, roughing and
grinding of metal and stone materials without
the use of water when equipped with a suit-
able disc and the appropriate guard.
The tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
