-15-
Maintenance And Inspection
CAUTION:
Always be sure that the tool is switched off and unplugged before attempting to perform
inspection or maintenance.
Maintenance of the motor
The motor unit winding is the very “heart” of the power tool. Exercise due care to ensure the
winding does not become damaged and /or wet with oil or water.
Inspecting the carbon brushes
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark
(
Fig. 18
). Keep the carbon brushes clean and free
to slip in the holders. Both carbon brushes should
be replaced at the same time. Use only identical
carbon brushes.
Use a screwdriver to remove the brush holder
caps. Take out the worn carbon brushes, insert
the new ones and secure the brush holder caps.
(
Fig. 19
)
※
Damaged cord must be replaced by a special cord purchased from authorized service
center.
※
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by authorized service centers, always using original
replacement parts.
Summary of Contents for ACS11-185
