-14-
Cutting Operation
CAUTION:
Be sure to move the tool forward in a straight line gently. Forcing or twisting the tool will
result in overheating the motor and dangerous kickback, possibly causing severe injury.
Do not stop the saw blade by lateral pressure on the disc.
The operator should avoid standing or exposure to the position of the circular saw cutting
debris and sawdust
Using goggles helps to avoid injuries.
Hold the tool firmly. The tool is provided with both a front grip and rear handle. Use both to
best grasp the tool. If both hands are holding saw, they cannot be cut by the blade.
Set the base on the workpiece to be cut without
the blade making any contact. Then turn the tool
on and wait until the blade attains full speed.
Now simply move the tool forward over the
workpiece surface, keeping it flat and advancing
smoothly until the sawing is completed. (
Fig. 16
)
To get clean cuts, keep your sawing line straight
and your speed of advance uniform. If the cut fails to properly follow your intended cut line,
do not attempt to turn or force the tool back to the cut line. Doing so may bind the blade and
lead to dangerous kickback and possible serious injury. Release switch, wait for blade to stop
and then withdraw tool. Realign tool on new cut line, and start cut again.
Attempt to avoid positioning which exposes operator to chips and wood dust being ejected
from saw. Use eye protection to help avoid injury.
Rip Fence (Guide Rule)
The handy rip fence allows you to do
extra-accurate straight cuts. Simply slide the rip
fence up snugly against the side of the
workpiece and secure it in position with the wing
bolt on the front of the base. It also makes
repeated cuts of uniform width possible. (
Fig. 17
)
Summary of Contents for ACS11-185
